registers first pick out which one to use
cisco when booting. dg how to type show version, usually
are in register 0 × 2102 or 0 × 102. On the Cisco 2600 series, is at
register 0 × 2120. following steps to reset the password cisco router:
1. Restart the router. at boot time about 10-60 seconds first press
break key on the keyboard. router will enter rommon mode>
2. Type confreg 0 × 2142 at the rommon 1>. register 0 × 214 will be posted by
pass nvram (which contains the startup configuration where the passwords are stored)
The next boot time.
3. Type reset at the rommon 2>. router will reboot, but ignore
startup configuration.
4. Dg Answer no to each question. or ctrl + c to skip
initial setup procedure.
5. You will go to Router> prompt. type enable to enter into
privileged exec mode (you will not be prompted for a password). prompt will
changes to Router #.
6. Type copy startup-config running-config command to copy all the configuration
imaginable in NVRAM to RAM. Not to reverse, copy runningcon
fig startup-config will remove your initial configuration (which is
in NVRAM).
7. To change the password, type configure terminal. prompt will
changes to Router (config) #
8. Replace password dg typing enable secret passwordanda
9. The result was copying configuration from NVRAM will cause all
interface down. to turn. as usual # config terminal
-> Interface FastEthernet0 / 0 -> no shutdown. as well as
netwrok interface else.
10. show running-config configuration will show who is running
which we will then write in NVRAM. The next copy con-
figuration that was the way to NVRAM dg command # copy running-config
startup-config
11. Return the router to register early (in this case register 0 × 2102). type
config-register 0 × 2102
12. Restartlah your router.
cisco when booting. dg how to type show version, usually
are in register 0 × 2102 or 0 × 102. On the Cisco 2600 series, is at
register 0 × 2120. following steps to reset the password cisco router:
1. Restart the router. at boot time about 10-60 seconds first press
break key on the keyboard. router will enter rommon mode>
2. Type confreg 0 × 2142 at the rommon 1>. register 0 × 214 will be posted by
pass nvram (which contains the startup configuration where the passwords are stored)
The next boot time.
3. Type reset at the rommon 2>. router will reboot, but ignore
startup configuration.
4. Dg Answer no to each question. or ctrl + c to skip
initial setup procedure.
5. You will go to Router> prompt. type enable to enter into
privileged exec mode (you will not be prompted for a password). prompt will
changes to Router #.
6. Type copy startup-config running-config command to copy all the configuration
imaginable in NVRAM to RAM. Not to reverse, copy runningcon
fig startup-config will remove your initial configuration (which is
in NVRAM).
7. To change the password, type configure terminal. prompt will
changes to Router (config) #
8. Replace password dg typing enable secret passwordanda
9. The result was copying configuration from NVRAM will cause all
interface down. to turn. as usual # config terminal
-> Interface FastEthernet0 / 0 -> no shutdown. as well as
netwrok interface else.
10. show running-config configuration will show who is running
which we will then write in NVRAM. The next copy con-
figuration that was the way to NVRAM dg command # copy running-config
startup-config
11. Return the router to register early (in this case register 0 × 2102). type
config-register 0 × 2102
12. Restartlah your router.
0 komentar:
Posting Komentar